Monophasic UV & LED Reconstruction Gel BUILDER MONO GEL CLEAR 50gr

HOW TO USE: 1. Disinfect the customer's hand with the sanitizing solution. 2. Push all cuticles with the cuticle pusher. 3. Clean the entire cuticle area thoroughly, eliminating residues. 4. Carefully mat the entire surface of the nail plate with the abrasive brick. 5. Carefully dust off all the dust produced with the special brush. 6. Apply a layer of Nail Prep and allow to air dry for 30 seconds. 7. Apply a coat of Ultrabond (non-acid primer) and allow to air dry for 30 seconds. Leave the sticky layer it produces after drying. 8. Place a small amount of Builder Mono Gel Clear in the center of the nail, near the C-curve. Work a thin layer of gel towards the cuticles and spread it towards the tip. Avoid letting the gel run around the cuticles. Leave a thicker layer of gel in the center of the nail in order to create a perfect C-curve. 9. Cure in a professional UV lamp (36 Watt) for 2 minutes or 1 minute in a LED lamp (36 Watt). If using a lower wattage lamp, extend the curing time by 1-2 minutes. 10. Apply a thin and even layer of Builder Mono Gel Clear on the entire surface of the nail and cure as indicated above. 11. Remove the sticky residue with UV Gel Cleanser. 12. File the nails into shape making them thinner near the cuticles and at the tips, and leaving them thicker at the point of stress. 13. Apply a thin layer of Builder Mono Gel Clear as a top gel or a finishing gel. 14. Cure as indicated above. 15. Eliminate the sticky residue again. WARNINGS: Keep the product in a cool and dark place. Do not expose to excessive heat or light. Use only as directed. Harmful if inhaled, may cause sensitization in contact with the skin. Avoid contact with the skin and eyes, after contact with the skin, wash immediately with plenty of water, wear suitable protective gloves. In the event of an accident or if you feel unwell, contact a doctor immediately (show this label if possible).